what is the best tape to use
Reply
|
KBT
Professional
 |
3 years, 10 months ago by KBT
mine always slips out I was wondering if anyone has suggestions.
|
|
ajr725
Bracelet King
 |
3 years, 10 months ago by ajr725
I usually just use scotch tape, but I have this problem sometimes too. I just have to use more than one piece of tape to avoid my bracelets slipping. Also, if you don’t like having to use so much tape for your bracelets, you could try using a clip board or a safety pin to secure them instead.
|
|
zero_knots
Professional
 |
3 years, 10 months ago by zero_knots
personally i prefer to not use tape and use a small clipboard, but i would recommend duck tape as it should be strong enough to hold it down
|
|
Ciao
Bracelet King
 |
3 years, 10 months ago by Ciao
I use duct tape, and I usually tie a temporary knot below where I put the tape to prevent it from slipping (even though it rarely slips with duct tape anyway)
|
|
juliannagh
Bracelet King
 |
3 years, 10 months ago by juliannagh
i just use regular scotch tape but sometimes it isn’t the strongest
|
|
chkntaters
Bracelet King
 |
3 years, 10 months ago by chkntaters
Duck tape sometimes leaves a sticky residue on your surface and bracelet. Like others have mentioned, scotch tape works well but masking tape or painters tape also works quite well in my experience.
|
|
brutie_pie
Bracelet King
 |
3 years, 10 months ago by brutie_pie
I use painters tape of a clipboard. They both work great but I prefer using a clipboard.
|
|
Clairaland
Bracelet King
 |
3 years, 10 months ago by Clairaland
I used to use 100 pieces of duct tape lol, now i use a clipboard
|
|
yurchenko9
Bracelet King
 |
3 years, 10 months ago by yurchenko9
I use washi tape since it doesn't fray/pilly my strings and it can be used a few times
|
|
madeleine_
Moderator
 |
3 years, 10 months ago by madeleine_
I use packing tape. To keep string from slipping out, you can tape the strings down and leave excess string above where you put the tape, then take the excess and fold it back down and put tape over it
|
|
Knots_EM
Bracelet King
 |
3 years, 10 months ago by Knots_EM
I use masking tape
|
|
beaumont
Moderator
 |
3 years, 10 months ago by beaumont
i like to use duct tape because that's the most secure tape
|
|
Ate_Trisha
Bracelet King
 |
3 years, 10 months ago by Ate_Trisha
use packing tape or duck tape they both work well form my experience
|
|
kerrs
Bracelet King
 |
3 years, 10 months ago by kerrs
i use duct tape!
|
|
estellajw
Professional
 |
3 years, 10 months ago by estellajw
packing tape works really well!!
|
|
stewon6969
Bracelet King
 |
3 years, 10 months ago by stewon6969
Well, I use duct tape mostly but it can tear my bracelet because it is very strong! So now I mostly use washy tape and it is great!
|
|
Pichu10
Bracelet King
 |
3 years, 9 months ago by Pichu10
Artminds tape works really well 😊
|
|
Sanaya564
Bracelet King
 |
3 years, 9 months ago by Sanaya564
i use a hugeeeee binder clip on a book i feel like the binder clips are stronger than a clipboard
|
|
Shelly2121
Bracelet King
 |
3 years, 9 months ago by Shelly2121
When i start out a bracelet, i use tape and a clipboard. Once the bracelet’s secure enough, i untape it, then continue making it.
|
|
xXMyselfXx
Professional
 |
3 years, 9 months ago by xXMyselfXx
I use a small clipboard an scotch tape. If mine is slipping anyway, I just tape some more pieces on the string. Good luck! 🍀
|
