Holes😖
Reply
|
prettyluvZ
Professional
 |
3 years, 9 months ago by prettyluvZ
I was doing good and they were tight but then holes started to appear😭
|
|
madeleine_
Moderator
 |
3 years, 9 months ago by madeleine_
Make sure that you make the first half of the knot tight, because that’s what determines the placement of it. Tying the first half loose but the second half tight will still result in holes. Also, make sure your knotting tension is consistent
|
|
syd643
Professional
 |
3 years, 9 months ago by syd643
Try making the first knot right and the second one a bit looser and do that to all of them hope this helps!
|
|
stewon6969
Bracelet King
 |
3 years, 8 months ago by stewon6969
Make your knots tighter! Try it! See if it works!
|
|
kiaraxmag
Advanced
 |
3 years, 8 months ago by kiaraxmag
the first half of your knot is what determines if there's holes or not, make sure it's tight but not too tight!!
|
|
OtterPop
Skiller
 |
3 years, 8 months ago by OtterPop
you should tie them really tight 👍
|
|
Diana2509
Bracelet King
 |
3 years, 8 months ago by Diana2509
I had the same problem many times! What I do is I always make the first knot tighter and the second loose, but if that won't work, try to refrain from stopping your work and stretching the bracelet out to see the design. I know it may sound weird, and you probably don't even do that, but that os what I used to do and it would cause holes.
|
|
clemseery
Advanced
 |
3 years, 8 months ago by clemseery
make sure your knots are really really tight!
|
Reply
